Turn rectangular dimensions into cubic yards and approximate tons using a typical dry bulk density.
Results use your measurements and editable assumptions. Verify product coverage, density, waste and order rounding with the supplier before purchasing.
Volume = area × depth; tons = cubic feet × density ÷ 2,000.
BuildCalc converts measurements to a consistent internal unit, applies your project geometry and only then adds the selected waste allowance. Packaging quantities are rounded up because partial bags, blocks or boxes usually cannot be ordered.
Sand products differ significantly in gradation, moisture and bulk density. Use this calculator for geometric volume first, then compare its approximate tonnage with a local supplier's product data. Measure each area separately when depths or sand types differ.
A 2 in layer over 200 square feet contains about 33.3 cubic feet, or 1.23 cubic yards. At an assumed dry bulk density of 100 lb per cubic foot, the weight is approximately 1.67 tons before waste.
Yes. Moisture can materially increase delivered weight, so a generic density conversion should be treated as an approximation.
Not reliably. Product gradation and moisture differ. Replace the planning density with supplier information whenever possible.
Published and maintained by EasyTool.me. Review the calculation methodology, verify product-specific values with the supplier, and report reproducible corrections. Last materially reviewed August 16, 2026.